Aleks ran the auto-tuning function of the SIS software (CANbus). The voltages determined were just slightly smaller than a few days ago, but there is also more LO power coming in (4 uAmps additional current). The auto-tuned voltage is 8.80V, (measuring 61.3 uA) for the cable labeled lcp and 9.00V (measuring 57.5 uA) for the cable labeled rcp.

Preparing now for Y-factor test.

Link to spreadsheet of data

We performed a Y factor test on the channel labeled LCP on the bench. First we went through Bias Voltages at the LO power that produced around 62uA of current through the SIS junction. Next we tested a subset of Bias Voltages where we tuned the LO power down such that the current in the junction was roughly 56 uA and then 40 uA. Results of that test in the image below.

image(1).png

While performing the test we noticed the 10 MHz signal was very clear in the oscilloscope. We also noticed that changing the LO power such that the current in the junction was nearly 62 uA (the blue curve) reduced the power of this 10 MHz signal. It seemed to be the "sweet spot" for minimizing this signal.

The best Y factor was 2.19 (lowest T_RX was 106 K), which was achieved with Bias Voltage of 8.6 and an LO power tuned such that the current in the junction was near 62 uA.

SIS Mixer tuning

From $1

Table of contents

Table of contents